Thick-Cut Rockfish Sashimi with a 3-Hour Refrigerator Rest

3시간 냉장 숙성한 두툼한 우럭회

Prepare a whole rockfish, remove the bones and skin, and rest the fillets in the refrigerator for 3 hours before cutting thick sashimi slices.

Written and edited by K-Food at Home

Recipe time: 3 hours refrigerated resting; total preparation time not specified

Thick-Cut Rockfish Sashimi with a 3-Hour Refrigerator Rest

Ingredients

  • 1 whole fish Whole rockfish (우럭)

Tools you’ll need

Fish scaler, fish preparation knife, sashimi knife, clean cutting boards, fish bone tweezers, absorbent fish wrapping paper, refrigerator, serving plate

Let’s make it.

1. Prepare the whole fish

Use: Whole rockfish

Cover the fish’s eyes to reduce movement. Scrape away scales at the cutting points, then make the demonstrated cuts at the head and tail.

Look for: The caption identifies the head and tail cuts as severing the nerves.

2. Remove the scales

Use: Prepared whole rockfish

Use a fish scaler under running water. Work carefully around the fins.

Look for: Remove scales around the areas where the knife will enter.

3. Remove the head and innards

Use: Scaled rockfish

Cut beneath the gills to separate the head. Open the belly to just above the belly fin and remove the innards.

Look for: The body is cleaned before filleting begins.

4. Rinse and dry

Use: Cleaned rockfish body

Rinse the cleaned fish and thoroughly remove surface moisture. Use a clean cutting board for filleting, keeping this work separate from scaling.

Look for: The fish is wiped dry on a clean preparation board.

5. Separate both fillets

Use: Dried rockfish body

Keep the head end to your right. Cut along the belly side first, then turn the fish and cut along the back. Release the first fillet from the central bones. Repeat on the other side, working from the back toward the belly.

Look for: Follow the demonstrated belly–back–back–belly order to obtain two fillets.

6. Trim the rib bones

Use: Rockfish fillets

Trim the belly bones from each fillet, keeping the blade close to the bones to preserve the flesh.

Look for: Lift away the rib section with as little flesh attached as possible.

7. Pull out the pin bones

Use: Trimmed rockfish fillets

Use fish bone tweezers to pull out the bones running through the center of the fillets.

Look for: Pull the bones individually to avoid cutting away a strip of flesh.

8. Remove the skin

Use: Deboned rockfish fillets

Start at the tail end and insert the knife between the skin and flesh. Work toward the head end while pulling and gently moving the skin to separate it.

Look for: The skin comes away in a sheet, leaving the flesh intact.

9. Rest in the refrigerator

Use: Skinless rockfish fillets

Wrap the prepared fillets in absorbent fish wrapping paper and refrigerate for 3 hours.

Look for: Unwrap the fillets after the refrigerated rest.

10. Slice and plate

Use: Rested rockfish fillets

Position each fillet with its lower edge facing you and cut into thick slices. If a slice feels too thick, score it with the knife. Arrange the sashimi on a serving plate.

Look for: The thick slices are scored and arranged on the finished plate.

Behind this recipe

Recipe reference: Original recipe and video.

Editorially approved · Not independently kitchen-tested.

Image credits

Browse all recipes